First Class Changing From Dimmer Switch To Normal

It is the type of dimmer with one switch which you touch to turn on and off and you keep your finger on it to change the brightness.

Changing from dimmer switch to normal. Basic electricians pouch hand tools a non aluminum ladder and voltage tester. Turn off the power to the switch at the circuit or fuse panel. Can anyone inform me how difficult this is to do.

This electrical wiring project is best performed by a licensed electrical contractor. It is a normal size as a regular dimming module so it can easily replace the existing dimmer in the back of your dimmer switch. Test the dimmer switch that you d like to replace to be sure that it no longer has power.

To replace a standard switch with a dimmer switch follow these steps. Then use a voltage tester to make sure that the circuit is dead. Do not proceed unless you are 100 sure that the power has been disconnected or you risk being electrocuted which may cause severe injury or death.

Secure it by tightening the screw then attach the traveler and or common wires from the switch box to the screws at the sides of the new switch in the same manner. Of course such a replacement should be done by a registered electrician don t try to do any diy with electricity and electrical devices such as these so that it may be tested and work properly. Hi i need to replace the dimmer light switch in my living room with a reglar on off switch.

Depends on personal level experience ability to work with tools and access to the light fixture s. Unscrew the switch from the electrical box and pull it out with the wires still attached. Disconnect the traveler and or common wires from the dimmer switch.

The first step is to turn off the power at the home s breaker box. Next using a pair of needle nose pliers wrap the bare ground wire around the green screw at the bottom of the new standard switch. Then use a screwdriver to remove the plastic wall plate.