Casual Light Switch With 2 Black And 1 Red Wire

If you join the two red wires together at the fitting in a suitable connector block or wago connector put one of the black wires in the live pot the switched live on the fitting and one of the black wires in the neutral pot and the green yellow.

Light switch with 2 black and 1 red wire. I have a light switch with two black wires one red and a ground answered by a verified electrician we use cookies to give you the best possible experience on our website. Typically the only switches wired with a red wire are multi way switches 3 wire ground black white red bare. There are two black wires attached to one brass screw and a red wire attached to the other brass screw.

If you are unsure you should really have a electrician come over and fit the light for you. So i have a switch that has one black load i tested it and it has 120v one white neutral and one red. Light switch with 2 black and 1 red wire.

The switch may have gold and silver colored screws. So far i can t seem to wire this to work. 12 awg for 20 amp circuits and 14 awg for 10 and 15 amp circuits.

Connect the black wire to the other brass screw. Maybe someone can help me. Join the white wires and cap them in the same way but omit the jumper wire.

I should also mention that it is 5 led lights. The white and bare wires are connected. From what you are saying it sounds like its the end of line for the lighting circuit therefore you have one permanently live cable and one switch cable.

4 way switches have 4 screws 2 will be black and 2 will be brass. There appear to be two white assume neutral wires screwed together with a wire nut and a ground wire tucked away inside the junction box. They should both be of the same wire gauge.